/ BGW /

BGW X5600 AMPLIFIER

> Designed for Musicians
> 900W per Channel
> 110 dB Signal to Noise Ratio

 


Unprecedented Speed, Control and Low Noise

This is the musician’s amplifier. A new classic design with a conventional power supply to insure the highest performance and best value available. This power supply features over 124,000uF of energy storage, so that every bass note is guaranteed to be heard. Several modes range in power from 1000 watts to 1500 watts per channel at 2 ohms and at 4 ohms, all three models range in power from 725 watts to 1500 watts per channel. BGW’s legendary modular design, unibody welded steel chassis construction and conservative multiple protection circuits make the X Series perfect for every gig. Even the front panel graphics say “Musician!”

Topology
Class AB with fully balanced differential design; 4-quadrant input stage, current feedback and dual DC Servos.

Warranty
3 years standard warranty

Description

The BGW X5600 is the musician’s amplifier. A new classic design with a conventional power supply to insure the highest performance and best value available. This power supply features over 124,000uF of energy storage, so that every bass note is guaranteed to be heard. Several modes range in power from 1000 watts to 1500 watts per channel at 2 ohms and at 4 ohms, all three models range in power from 725 watts to 1500 watts per channel. BGW’s legendary modular design, unibody welded steel chassis construction and conservative multiple protection circuits make the X Series perfect for every gig. Even the front panel graphics say “Musician!”

The BGW X5600 uses barrier strip and monitor speaker output connectors. It has up to 2400 Watts with bridge monopower and a 107dB signal to noise ratio.

View all BGW products here.

Follow us on Facebook

Specifications

Input

Connectors
Balanced XLR

Attenuation
One 21 position detented rotary control precision input attenuator per channel. One (1) dB attenuation steps.

Input Impedance
11 kΩ

Input Sensitivity
0.775 Vrms for rated 8 ohm output

Gain
34.7 dB

Polarity
XLR Pinout (Pin 1 = Ground, Pin 2 = Positive, Pin 3 = Negative,)

Dimensions & Power

Dimensions
478mm x 482.5mm x 133.4mm (LxWxH)

Mass
Weight Up to 32kg

Power Requirements
7.5 A @ 230V AC 50-60 Hz

Output

Output Power
900 W/ch @ 8Ω (Stereo Mode)
1500 W/ch @ 4Ω (Stereo Mode)
2300 W/ch @ 8Ω (Bridged Mono)

 

FTC
(Continuous Average Power Rating 20Hz – 20kHz @ .05 THD or less)EIA
(Continuous Maximum Power Rating 1kHz @ 1% THD)CEA
(Instantaneous Peak Power Rating – 1kHz @ 1% THD)

Distortion
Typical THD<0.008%
Maximum THD 1.0%
IMD<0.008%

Slew Rate
20 V/µs (Stereo Mode)
40 V/µs (Mono Mode)

Damping Factor
>300:1 (ref. 8Ω)

Crosstalk
>90 dB @ 20 Hz – 20 kHz

DC Offset
<10 mV (5 mV typical)

Recommended load
4/8 Ω

Frequency Response
8 Hz – 56 kHz, +0/-3 dB
20 Hz – 20 kHz, +0/-0.3 dB

Signal-to-Noise Ratio
>110 dB referenced to rated output (A-Weighted)

Speaker Outputs
5-Way Binding Posts